Furnace Parts - Control Boards - Honeywell S8910U1000 Universal Hot Surface Ignitor Module

Furnace Parts > Control Boards > Honeywell S8910U1000 Universal Hot Surface Ignitor Module

Honeywell S8910U1000 Universal Hot Surface Ignitor Module

Universal Hot Surface Ignition Module is designed to provide easy field replacement of a wide range of hot surface ignition modules manufactured by Honeywell, Robertshaw and White-Rodgers. The S8910U Module provides operating control of a direct ignition system using a 120 Vac hot surface igniter.

$ 132.74 Back
Quantity:

Description Provide electronic control of direct hot surface ignition systems used on gas fired furnaces, boilers, and other heating appliances.
Ignition System Type Direct Hot Surface Ignition
Ignition Sequence The number of trials for ignition and trial time is determined by the selection tab. If a selection tab is not installed, the module will operate at four seconds trial time and one ignition trial.
Typical Gas Control VR8205, VR8305
Type of Gas Natural or LP
Flame Sense Single Rod or Two Rods
Ignition Source Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270)
PrePurge 32 seconds
Ignition Trials To Lockout 1 or 3
Lockout Timing 4 sec. or 7 sec.
Ignition Trial Time (sec) 4 sec. or 7 sec.
Maximum Valve Load @ 24 Vac (Amps) 2A
Typical Ignition Hardware Norton 201, Norton 271, Q354
Dimensions (in.) 5 1/4 in. high x 4 1/16 in. wide x 1 15/16 in. long
Dimensions (mm) 133 mm high x 103 mm wide x 49 mm deep
Electrical Ratings 24 Vac
Frequency 60 Hz
Maximum Ambient Temperature (F) -40 F to +175 F
Maximum Ambient Temperature (C) -40 C to +79 C
Approvals, Canadian Standards Association Design Certified
Tradeline Value Super Tradeline
Between Trial Time (sec) (2) 96 sec.- 3 trial mode only
Flame Failure Response Time (sec) 1.5 sec.